Kenton Linndrum Mk3 - Manual (Page 2)

You can also set channels etc on the Linn itself as described below
The top row of eight buttons (Hihat 1 thru Ride 2) are Rx Tx channel
numbers 1 to 8 and they become 9 to 16 if the percussion led is lit.
On the bottom row, Bass 1 selects Receive chan, Bass 2 selects Transmit
chan, Sidestick selects [omni-on mode], Snare 1 selects [omni-off mode],
Snare 2 selects [disable start/stop codes RX & TX through MIDI], Snare 3
selects [enable start/stop codes TX & RX through MIDI], and Crash is the
ENTER key to return you to the normal operating state.
So the sequence of events is :- Red push button - (then optionally
omni on or off) - then recieve or transmit select [bass 1 or 2] -
then a channel number [1 thru 16] - then press crash to ENTER
As an example - to get transmit channel 5 and receive channel 10, but
leave it in omni-off mode.
1) Press the red button
2) Press Bass 2 (transmit select)
3) Press Mid tom (perc led not lit) [transmit ch 5 now set]
4) Press Bass 1 (receive select)
5) Press Percussion button (to get to channels 9 to 16)
6) Press Cabasa 2 (perc led lit) [receive ch 10 now set]
7) Press Crash - to ENTER (return to normal operating mode)
Note that when the red button has been pressed, the panel buttons
will not make sounds when pressed, until normal playing mode is
resumed by pressing ENTER (Crash).
OPERATION OF DRUM BUTTONS IN SET-UP MODE
------ ------ ------ ------ ------ ------ ------ ------
| Chan | Chan | Chan | Chan | Chan | Chan | Chan | Chan |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 |
------ ------ ------ ------ ------ ------ ------ ------
------ ------ ------ ------ ------ ------ ------ ------
| Omni | Omni | Dis- | En- | RX | TX | | Sel |
| | | able | able | | |ENTER | 1-8 |
| on | off | START & STOP| mode | mode | | 9-16 |
------ ------ ------ ------ ------ ------ ------ ------
Red percussion light off = chan 1-8
Red percussion light on = chan 9-16
Assign mode cannot be used from the front panel buttons