Kenton Micromoog - Manual (Page 5)

NOTES
1) Controllers X and Y can each be any MIDI controller.
After pressing the red push button to enter SET-UP mode, operate
the required MIDI controller before pressing the key(s) that will
assign it.
If you do not operate any controller before pressing the key(s)
then controller X will default to MIDI controller 16 (10 hexadecimal)
- that is General purpose controller 1
or controller Y will default to MIDI controller 17 (11 hexadecimal)
- that is General purpose controller 2
2) Controller X/Y will take priority over other control messages,
so if controller X/Y is the mod wheel, mod wheel messages will be
"hijacked" to operate whatever controller X/Y is currently assigned
to, instead of operating modulation.
3) Receive channel and omni-on setting will return you
directly to playing mode, all other keys will let you stay in SET-UP
mode until you press the ENTER key (Top C)
4) The ENTER key (Top C) also resets all controllers to their
default values - off in most cases - on for volume - centre for pitch
bender etc.
5) After pressing the red push button twice to enter set-up mode,
the first assignment that you make for any given source (after-touch
for example) will cancel all other destinations currently assigned to
that source - if you want to make multiple assignments, you will have
to do this in the same set-up session, in other words, before you press
top C.
- For example - irrespective of what aftertouch was previously assigned
to, pressing F (and release) will assign it to VCF only.
- to make aftertouch also bend pitch, you will also have to press E
( and release) before pressing the top C which will ENTER the
information and store it in n.v. memory.
OTHER SET-UPS WILL REMAIN UNALTERED UNLESS SPECIFICALLY CHANGED
6) Control change commands recognised - (numbers in decimal)
121 reset all controllers 01 modulation wheel
123 all notes off 07 main volume
124 omni mode off (always poly) 64 sustain pedal
125 omni mode on (always poly) 94 select transpose mode
126 (mono mode) = all notes off 95 select set-up mode
127 (poly mode) = all notes off
nnn Controller X (user defined where nnn = any controller)
nnn Controller Y (user defined where nnn = any controller)
7) Other commands recognised - (numbers in hexadecimal)
8nH notes off 9nH notes on & velocity
BnH control change (see above)
DnH channel pressure (aftertouch) EnH pitch-bend change
FEH active sensing