Kenton Opus - Manual (Page 3)

NOTES
1) Controller X can be any MIDI controller.
After pressing the red push button twice to enter SET-UP mode,
operate the required MIDI controller before pressing the C or
Db key that will assign it to VCF or ***.
If you do not operate a controller before pressing the C or
Db key, then controller X will respond to MIDI controller
16 - that is General purpose controller 1 (10 hexadecimal)
2) Controller Y can be any MIDI controller.
After pressing the red push button twice to enter SET-UP mode,
operate the required MIDI controller before pressing the A or
Bb key that will assign it to VCF or ***.
If you do not operate a controller before pressing the A or
Bb key, then controller Y will respond to MIDI controller
17 - that is General purpose controller 2 (11 hexadecimal)
3) Controller X/Y will take priority over other control messages,
so if controller X/Y is the mod wheel, mod wheel messages will
operate whatever controller X/Y is currently assigned to,
instead of operating modulation.
4) Transmit/Receive channel and omni-on setting will return you
directly to playing mode, all other keys will let you stay in
SET-UP mode until you press the ENTER key (Top C)
5) The ENTER key (Top C) also resets all controllers to their
default values - off in most cases - on for volume - centre
for pitch bender.
6) After pressing the red push button twice to enter set-up mode,
the first assignment that you make for any given source (after-
touch for example) will cancel all other destinations currently
assigned to that source - if you want to make multiple assign-
ments, you will have to do this in the same set-up session, in
other words, before you press top C.
- For example - irrespective of what aftertouch was previously
assigned to, pressing F (and release) will assign it to VCF only
- to make aftertouch also bend pitch, you will have to press E
( and release) before pressing the top C which will ENTER the
information and store it in n.v. memory.
OTHER SET-UPS WILL REMAIN UNALTERED UNLESS SPECIFICALLY CHANGED
7) Control change commands recognised - (numbers in decimal)
121 reset all controllers 01 modulation wheel
123 all notes off
124 omni mode off (always poly)
125 omni mode on (always poly) 94 select transpose mode
126 (mono mode) = all notes off 95 select set-up mode
127 (poly mode) = all notes off
nnn Controller X (user defined where nnn = any controller)
nnn Controller Y (user defined where nnn = any controller)
Controller X default = 16 Controller Y default = 17
8) Other commands recognised - (numbers in hexadecimal)
8nH notes off 9nH notes on & velocity
BnH control change (see above) CnH program change
DnH channel pressure (aftertouch) EnH pitch-bend change
FEH active sensing