Kenton Poly(supplied prior to mid 1990) - Manual (Page 2)

C Receive channel 1 [ Bottom C ] Midi note number 36
Db " " 2
D " " 3
Eb " " 4
E " " 5
F " " 6
Gb " " 7
G " " 8 Selecting a receive channel
Ab " " 9 will automatically put the
A " " 10 Midi into omni off mode.
Bb " " 11 That is, it will receive on
B " " 12 the selected channel only.
C " " 13
Db " " 14
D " " 15
Eb " " 16
E Not used
Master reset (G) sets all
F Omni on mode (default) settings to their default
Gb Not used values. Also sends all notes
G Master reset (see note) off code through midi. Press
Ab Not used and hold down this key and
A Ignore received master reset then also press top C.
Bb Not used
B " "
C Transmit channel 1 (default) [ Middle C ] Midi note number 60
Db " " 2
D " " 3
Eb " " 4
E " " 5
F " " 6
Gb " " 7
G " " 8 The transmit channel can be
Ab " " 9 changed independently of the
A " " 10 of the receive channel, and
Bb " " 11 can be set even during omni
B " " 12 on mode.
C " " 13
Db " " 14
D " " 15
Eb " " 16
E Not used
F Transmit Key on velocity decrease :
Gb " " " " normal (default) :
G " " " " increase :
Ab Not used
A Transmit Key off velocity decrease :
Bb " " " " normal (default) :
B " " " " increase :
C Receive program change (default)
Db ignore " "
D receive mod wheel (default)
Eb ignore " "
E receive pitch wheel (default)
F ignore " "
Gb receive after touch (default)
G ignore " "
Ab send velocity information to vcf/vca (default)
A send nothing to vcf/vca
Bb send controller 4 information to vcf/vca
B send aftertouch to vcf/vca (instead of to modulation)
C ENTER key - Press and release. [ Top C ] Midi note no. 96