Kenton Pro-4 - Manual (Page 9)

9
EDITING THE PRO-4
The PRO-4 is very easy to use. It uses a standard system of editing. It has a clear and informative 2x20 LCD
with backlight, PARAMETER and VALUE buttons, and a Data Entry Dial (referred to as the DED).
To select the parameter you wish to edit, the parameter LED (the red light emitting diode), must be lit. If it
is not, press the PARAMETER button. You can now scroll through the parameters using the DED.
To edit a value, press the VALUE button. The value LED will light up. Now by turning the DED the parameter
value can be edited. Note that with many of the larger values (such as controller numbers and
portamento rate) the values will loop from max to min, i.e from +127 directly to -127.
STORING AND RECALLING SET-UPS
To load a set-up, press LOAD.
Now with the DED, you can select which set-up, 1 to 8, you wish to load, or you can load back the
default settings.
After selecting which set-up you want, press & hold LOAD till the display says LOADED.
The PRO-4 can be set to receive a SYSEX data dump. See SYSEX manual for full details on PRO-4 MIDI
System Exclusive.
To store a set-up, press STORE.
Now with the DED, you can select which memory, 1 to 8, you wish to store your set-up in.
After selecting which memory you wish to store your set-up in, press and hold STORE till the display says
STORED.
The PRO-4, the current set-up, or all 8 set-ups can be dumped by SYSEX.
Lastly, the system data can also be stored. This comprises of the display contrast, MIDI device number
and The Auto-Load setting.