Keri Systems LAN-520 - Manual

LAN-520 AESP
Installation Guide
Page 1 of 13 P/N: 01519-001 Rev. B
1.0 Basic LAN Device Setup
The following are basic setup instructions for the LAN-520 AESP. Some settings may not apply to every application.
NOTE: The LAN-520 AESP is an updated version of Keri’s LAN-520X device. If you are using the new NC-485X
Network Converter with the LAN-520, you must use the LAN-520 AESP module (or the existing LAN-520X module).
The original NC-485 Network Converter is NOT compatible with the new LAN-520 AESP (or the existing LAN-520X
module).
NOTE: To set up the LAN-520 AESP, you MUST have technical knowledge of general networking in a PC
environment. Please have a Network Administrator on site to resolve any special networking issues that might occur
during device programming. Network topologies and strategies will vary.
Figure 1: The LAN-520 AESP Unit
LAN-520 AESP
10/100 Ethernet/MAC Port
4 Status LEDs
RJ-45
Connector
Power Cycle Switch
Reset to Factory Default Jumper
MAC
Address
Label
mac addr
ess