Keri Systems LAN-520 - Manual (Page 4)

LAN-520 AESP
Installation Guide
Page 4 of 13 P/N: 01519-001 Rev. B
4.0 DHCP Setting
The new LAN-520 AESP has DHCP enabled by default. When the LAN-520 AESP module is connected to a DHCP
enabled router it automatically receives an IP address. The quickest way to find out what DHCP address has been
assigned to the module is to install and run Lantronix Device Installer.
4.1 Installing the Lantronix Device Installer
The Lantronix Device Installer program is found on the software disc. You will not need an active internet connection as
all the required components are included in the installation program.
1. Explore the contents of the installation disk and locate a folder named 'Lantronix Device Installer'.
2. Double-click the 'Installer_KeriSystems' executable.
3. If you are using the Doors.NET software you will see the same 'Lantronix Device Installer' folder on the disk but
inside there will also be a subfolder named 'Updated_Lantronix'. Go into that folder and double-click the
'Device_Installer_v4' executable.
4. You should see a notification window informing you that .NET Framework and Device installer are both required
along with their version numbers. The .NET call out will not appear if the .NET Framework 4.0 is already installed.
5. Click Install to proceed.
6. Place a tick in the checkbox to confirm you have read the Microsoft Terms and Agreements.