Keri Systems EntraGuard Platinum Installation Guide - Manual (Page 9)

EntraGuard
®
Platinum Telephone Entry Controller
Installation Guide
Page 9 of 10 P/N: 01553-001 Rev. D
Figure 10: Clearing Memory
4.3 Diagnostics and Troubleshooting
For information regarding the diagnostics screens and troubleshooting the EntraGuard Platinum Controller, see the
EntraGuard Troubleshooting and Diagnostics Guide (P/N 01912-001).
4.4 LCD Setup
The EntraGuard LCD (located on the front of the EntraGuard Platinum controller) is capable of using two different font
sizes. The default is set for the large size. However, if the small size font would be preferred as the default, it may be
changed through the reset menu. From the Reset Menu (see Figure 6 on page 7), press 5 for LCD Setup. The LCD Setup
menu will appear on the LCD (see Figure 11).
Figure 11: Setup LCD Menu
1. Select 5 on the keypad to change the default font size. The Set Font Default Menu appears (see Figure 12).
Figure 12: Set Font Default Menu
2. Press 1 to make the default font small.
3. Press 2 to make the default font large.
NOTE: Users may temporarily change the font size when using the EntraGuard Platinum controller, but any changes
made will always return to the default as selected here.