Cobra Electronics 15 BAND XRS 9770 - Manual (Page 11)

Nothing Comes Close to a Cobra ® 17
Settings
Your Detector
16 English
Settings
Your Detector
Tone Visual Display Voice
One beep IntelliMute not set
Please try again
IntelliMute not set
Please try again
One beep IntelliMute Off IntelliMute Off
NOTE
If the unit is unable to sense usable pulses within
three seconds or if you do not set a rev point within
20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn Off.
IntelliMu...
Please tr...
IntelliMute
Not Set
Setting IntelliMute RRMs
Intelli
Mute
Off
IntelliMute Off
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set IntelliMute. Tone Visual Display Voice
None Set IntelliMute None
Press and release the Set/City button to
begin setting IntelliMute RPMs.
Two beeps Press SET
at desired
RPMs…
Set Engine
Revs
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
None None None
At the desired rev level, press and
release the Set/City button.
Three beeps IntelliMute
Set! IntelliMute
Set
Press and release either the Select/Dim
button to proceed to the next user mode
or the Program/Mute button to exit the
Program mode.
None None None
Set Intel... PressSET... Intelli
Mute
Set!
IntelliMute Pro
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as
VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for
use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector’s radar detection circuits are turned Off to prevent
detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set
the IntelliMute activation point. (See pages 14 through 16.)
To Turn IntelliMute Pro On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to IntelliMute Pro.
Tone Visual Display Voice
Two beeps IntelliMute Pro On,
then i blinks
in the display
IntelliMute Pro On
One beep IntelliMute Pro Off,
then i is
steady in the
display
IntelliMute Pro Off
N W i h
IntelliMute Pro On
Intelli
Mute Pro
On
IntelliMute Pro Off
Intelli
Mute Pro
Off
N W i h
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
Program/Mute Button
Set/City
Button
Select/Dim
Button
XRS9770_MANL.indd 16-17 8/30/10 8:39 AM