Keri Systems BioPointe Installation Guide - Manual (Page 7)

Keri Systems, Inc. 7 01956-001 Rev. A
www.kerisys.com
Enrolling a Master User
When you first receive the device, there are no enrolled fingerprints. The first
person to enroll becomes the first master of the device.
1. Press [Circle] [Circle] [1]
The LEDs light up per the table below (refer to the Front of Unit drawing on
Page 2).
LED 1 LED 2 LED 3
Amber – Steady ON Red – Slow Blink Amber – Slow Blink
2. When LED 2 starts to blink slowly in red, enter a 4-digit ID. The 4-digit ID
is the User ID. When the User ID is accepted, LED 2 will blink fast in red as
shown below. The fingerprint sensor will also light up signifying it is ready to
read.
LED 1 LED 2 LED 3
Amber – Steady ON Red – Fast Blink Amber – Slow Blink
3. When the fingerprint sensor lights up, place your finger on it to begin the
enrollment process. Each successful enrollment requires two image captures.
After the first image has been successfully captured, the sensor will go off.
You will then hear a series of beeps acknowledging the read.
4. When you hear the series of beeps, lift up your finger and wait for the
sensor to light up a second time. Place your finger back on the sensor. If this
second capture image is successful; LED 1 will blink green briefly, then return
to amber.
LED 1 LED 2 LED 3
Green – Blink Once
Amber – Steady ON
You can enroll up to three fingerprints for each User ID. LED 2 will blink fast
in green in preparation for enrolling the next finger. Press [#] to continue, or
[*] to exit.
LED 1 LED 2 LED 3
Amber –Steady ON Green – Fast Blink Amber – Slow Blink