KERN & SOHN HN-D - Manual (Page 3)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
HN-D
HN-D-BA-e-1213 3
2. Menu & Select“
3. “Print“
4. „ON / OFF & Back“
5. + : „Hardness Calibration“: press and hold ,
then press for 2 seconds to display the calibration
mode.
6. + : „Delete“: Press and hold , then press
to delete the current data.
7. + : „Set date and time“: in shut-off state, press
and hold , then press to set date and time.
8. + : „Data browse“: Press and hold , then
press to enter data browse.
5.2 LCD Display
5.3 Settings
5.3.1 Material Type
In measurement mode, press three times and the
material character will highlight, and then press to
select the material type. It changes according to the
following sequence:
Note: 1. It is necessary to select this classification. If
the material type is not known, it has to be referred to
the handbook.
2. When you change the material group, the impact
times counter will be set to “0” again.
5.3.2 Hardness Scale
In measuring mode, the button has to be pressed twice,
then the hardness scale character will be highlighted. It
has to be pressed to select the hardness scale; The
hardness scale changes according to the following
sequence:
Illustration: highlighted Hardness Scale character
HLD= Leeb Hardness
HB= Brinell
HRB= Rockwell (B)
HRC= Rockwell (C)
HV= Vickers
HSD= Shore Hardness (D)
Note:
1. The value “---“ means „out of range“.
2. The default hardness scale is HLD.
5.3.3 Data in One Group
In measurement mode, the button has to be pressed
four times, the „Data in One Group“ character will be
highlighted; then has to be pressed to set the number.
The maximum number is 9.
5.3.4 Browse Data
1. To browse the data in the current group: in
measurement mode, the button has to be pressed
once, the “impact time” character will be highlighted. Then
the button has to be pressed to browse the data in the
current group.
2. Browse the historical data: in measurement mode,
has to be pressed and held. Then has to be pressed
to display the historical data browse mode.
By pressing the button , the next group can be selected
and by pressing the button , the previous group can be
selected. If the button is pressed, the selected data
can be browsed: By pressing the button , the next group
can be selected and by pressing the button , the
previous group can be selected. You can return to the
previous menu by pressing the button .
Illustration: Browsing the data group: