KERN & SOHN TU 300-0.01US - Manual (Page 9)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
TU_US
TU_US-BA-e-1212 9
4.17 Auto Power off
The instrument features an “auto power off” function
designed to conserve battery life. If it is not in use for 5
minutes or more, it will turn itself off. If the voltage of the
battery is too low this function will also work.
4.18 System reset
The key has to be pressed while powering on the
instrument: factory defaults will be restored.
All the memory data will be cleared during system reset.
The only time this might be helpful is if the parameter in
the instrument was somehow corrupted.
4.19 Connection to PC
This instrument is equipped with a RS-232serial port.
Using the accessory cable, the instrument has got the
ability to connect to a PC or an external storage device.
Measurement data stored in the memory can be
transferred to the PC through the RS-232 port. For detailed
information of the communication software and its usage,
refer to the software manual.
5. Menu operation
Both, presetting system parameters and the additional
function are verified by menu operation. On the
measurement screen, the key has to be pressed to get
into the main menu.
5.1 Enter the main menu
To enter the main menu, the key has to be pressed to
activate the menu items tab while being on the
measurement screen. To turn back to the previous screen,
the key has to be pressed again.
5.2 Enter the Sub menu
The key has to be pressed to enter the submenu
screen while the submenu item is selected.
5.3 Change the parameter
The key has to be pressed to change the value of a
parameter while the item is selected on the parameter set
screen.
5.4 Numeric digit input
The key has to be pressed multiple times to tab to the
numeric digit to be changed; the numeric values on the
display can be decreased/ increased with the and
key until the desired value is matched.
5.5 Save and exit
The key has to be pressed to confirm the modification
and to return back to the previous screen.
5.6 Cancel and exit
The key has to be pressed to cancel the change and
return back to the previous screen.
6. Servicing
+
-
+
-
Cat
Anod
M iTec
MT200
Procedure:
1 Power Off the
instrument
2 Take off the cover of
the battery and take out
the two batteries
3 Insert the new
batteries into the
instrument
4 Replug the battery
cover
5 Power on the
instrument to check.
T
h
e M
ai
n
D
is
p
la
y
In
ter
face
Test Set
Print Set
Memory Manager
System Set
System Info
Work mode
2-Point Cal
Velocity Set
Probe Set
Tolerance Limit
Resolution
Unit
Print Current
Print Memory
Print All Mem
Auto Save
Key Sound
Warn Sound
LCD Brightness
View Mem Data
Delete by File
Delete all Data