KERN & SOHN TB 2000-0.1F - Manual (Page 3)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433-9933-199
Fax: +49-[0]7433-9933-149
Internet: www. sauter.eu
Instruction Manual
TB
TB-BA-e-1212 3
The black chequered pole segment is movably seated on a
spring. By means of the spring, the sensor tip presses onto
the test object with a defined force. This way,
measurement errors can be avoided.
It is recommendable to effect several test measurements
before the first use of the instrument. This way, further
measurement errors can be avoided.
10. Considerations / Trouble-shooting
10.1 The sensors of coating thickness gauges are to be
replaced only by identical types or series.
Otherwise the accuracy of measurement may be
affected or the gauge might be damaged.
10.2 The gauge should always be calibrated on the base
material used for the actual measurement, not on the
base plate included in the delivery.
10.3 The sensor will eventually be worn off. Its life will
depend on the number of measurements taken and
how abrasive the coating is.
.
11. Declaration of conformity