KERN & SOHN FL 1KG - Manual (Page 3)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.sauter.eu
Instruction Manual
FL
FL-BA-e-1210 3
Peak-Compression mode
Press MODES key until appears on the
display. The display will show the maximum compressive
force. See Figure 3c
Resetting the gauge
Press RESET key to clear both maximum registers and
prepare for detecting the next maximum readings.
Backlight Display
If any key is pressed or forces are applied to the load
sensor bigger than 0.5 % of full scale, the backlight be
activated for 60 seconds.
Saved reading to memory
Any reading can be saved anytime by pressing
MEM/ENTER key. A total of 500 readings can be stored in
the database included the reading unit.
Computer Control of Force Gauge
A computer can control the force gauge by sending RS-
232 commands.
RS232 output signal
The displayed reading may be transmitted to PC by
pressing the PRINT key or sending request command from
PC to the gauge.
10. Main Menu
Press MENU/ESC key to access the main menu. To move
between the option listed on the main menu page, press
UP and DOWN arrow keys to move the cursor. Press
ENTER to select the sub-menus, activate feature and
enter values. Within sub-menus UP, DOWN, LEFT and
RIGHT arrow keys will also change numerical values.
Press ESC to return to the main menu page.
Figure 4
1) AUTO-OFF
Press the MENU key, the display will show the main menu
page and use UP and DOWN to move the cursor point to
AUTO-OFF.
Press the ENTER key. The display will show the Auto-off
menu page.
Press ESC key to return to the main menu page.
An Auto-off feature can be enabled to conserve battery
power where the gauge powers down after 5,10 and 15
minutes (depending on Auto-off time) since the last key
has been pressed. The AO will appear in the main display
if you activate this feature.
Figure 5
Use UP and DOWN key to move the cursor. Press the
ENTER key to select auto-off option and return to main
menu page.
2) PASS-FAIL
The Pass-Fail feature used to set a defined acceptable
maximum and minimum forces gap for measuring. It is
activated by setting the lower level and upper level forces
limit. If the forces value is within the gap level, the display
will show message PASS. Any reading values outside this
gap (higher or lower), the display will show message FAIL.
If you activate this feature the PF symbol will be shown on
main display.
To access PASS-FAIL menu, Press UP and DOWN to
move the cursor point to PASS-FAIL and press the ENTER
key the display will show the Pass-Fail menu page. Press
ESC key to return to the main menu page.