Kuzma 4POINT 110630 - Manual (Page 12)

Fig.11 Removing vertical trough Fig.12 Removing horizontal trough
Fig.13 Both troughs removed
10. Cueing device adjustment
Should you find that in the ‘up’ position the cartridge is too high or too low above the record
then the cueing device can be raised or lowered. This can be done simply by using Allen key
1.5 mm:
Insert key into screw on side of arm rest.
Release screw, raise or lower device and retighten.
Rotation of cueing device can affect the drift of cartridge while travel vertically down.
The cueing device may lift slightly as the screw is retightened. Do not over-tighten as this
may cause the cueing device to stick in the ‘up’ position. Should this occur, slightly release
the screw. (Fig.9)
12