Kuzma AIR LINE 130401 - Manual (Page 6)

4.0. Air supply Setup:
4.1. Compressor:
Note: The working cycle of the compressor takes around 2 minutes building up pressure
from 6 to 8 bars and then cooling down for 2 minutes (not working). It is necessary to
monitor this cycle occasionally!
Everything is set and checked by Kuzma Ltd. The only item to be added is oil inside the
compressor and air intake filter, which must be fitted after transport.
If the compressor is in an upright position, it can be moved safely.
For more details see instructions with the compressor.
If the working cycle is longer then 4-5 minutes (heating the compressor), and stand by
(cooling) shorter then 1 minute, stop using the compressor and check maintenance, FAQ
( web) or “troubleshooting“ pages.!!!
When you first turn ON compressor it will take a bit longer time (3-5 minutes) to fill the
reservoir from zero to 8 bars. But the compressor must be connected to the air supply tube.
Note: The compressor has a safety valve and overheating protection!
Note: Do not position it in a small non ventilated space!
Note: The compressor is factory adjusted to a higher pressure (8 bar-120 psi) than quoted in
the Compressor Instruction Manual. (See label at the side of the cover!)
Note: Do not switch on the compressor before filling with oil and connecting the air intake
filter. Also insure that all air supply tubes are connected.
Note: Oil should last for at least 5 years of normal use and should be replaced when it is
very dark - almost black in colour.
Note: Check water condensation occasionally, 1-3 months approx.
Fig.2 Front of the compressor
6
Compressor pressure
indicator-reservoir
Mains switch
Pressure regulator
Output pressure indicator
Output tube-quick fit conn.
Drain bottles tubes
bbottlesbotlesbottles
Dust & moisture filters