Kuzma Stabi M 130524 - Manual (Page 6)

3mm gap between the frame and the outer edge of the top of the plate. When gently pushed
down with both hands it will barely move.
Remove the protection cup from the bearing shaft. Be sure that it is clean. Locate the PVC
bottle with bearing oil and cut the top off the nozzle to allow drops to be poured onto the
shaft.
Altogether pour 35 drops of oil. This is not critical as any surplus will be caught in the lower
reservoir. By squeezing the PVC bottle pour 8-10 drops of oil in the well, which contains the
ruby ball. Then, by nearly touching the edge of the well with the dropper, allow the rest of the
oil to slowly run along the shaft into the lower well. Have a tissue handy in case of oil
spillage.
Clean your hands in case of oil contamination.
Gently position the subplatter over the shaft and slowly lower it down. A small amount of oil
& air might escape from the hole on the slope. If so, wipe it. Gently rotate the subplatter a
few times, lift it up half way and lower it again. It should rotate smoothly.
Top plate with subplatter and belt
Belt:
Position the belt onto the motor pulley first and then with fingers position belt over subplatter
perimeter. The belt is not very flexible but just stretch it into position by rotating the
subplatter a few times.
6