Kuzma Stabi M 130524 - Manual (Page 8)

Be sure that you have an armboard with the correct pre-cut. Mount armbase on the armboard
and then mount armboard on the turntable with four Allen keys. Fix firmly. The armboard
can be fixed in both directions, so be sure you mount it correctly orientated.
If necessary a
second cut can be made on the armboard, but this is made of aluminium.
Mount the arm as instructed in the tonearm instruction manual. Route the tonearm cable
underneath the turntable below the armboard.
With tonearms where the cable is not
connected to the tonearm below armboard, eg. 4Point, Air Line,….., the tonearm must be
fixed on the armboard before it is fixed onto the turntable. Position the cable into the gap on
the armboard, into the hole below the armboard and outwards through the hole on the rear of
the turntable panel. It is easier done by two people. Then mount armboard with tonearm onto
the top plate ( main frame) ensuring that the cable is not in the way.
It is necessary to readjust the height due to the added weight. Do this as described before, by
levelling it with outer frame and re check horizontally with spirit level.
Rear panel ( hinges & XLR connections)
Lid:
Insert the lid in the appropriate slots on the rear wall of the main frame. Lift it out in open
position!
Power supply:
DC power supply
8