Kuzma Stabi XL 2 101014 User Manual
Page 12
12
Problems:
Platter not rotating:
Power supply- check if green display and red LED is on
-check selector to 33 rpm
- check connection cables from PS to motor
Consult dealer or qualified electrician.
Very slow start:
Only one motor is connected or one output channel of the PS has failed. Remove the platter
and belts and check that the motor pulleys are rotating. If only one motor pulley rotates,
disconnect the mains and connecting cables from the PS and reconnect the non- rotating
motor to the output of the second motor to check is there is a motor failure or a failure of
the PS.
Wrong speed:
If you find out that your speed selection is out of range for some reason you should reset PS to
factory sert outputs.
Turn the power off, wait 10 sec and then press and hold speed button, then press power on.
When display will shows CU, release the speed button. The display will now show FA and
then 33. Your PS is now preset for factory preset speeds.
A.Speed:To reach correct speed, adjusted it on the PS. Also check that the distance of
motors to the platter are correct.
B.If the speed is totally incorrect: Reset to factory preset.
Finally repeat factory preset and fine speed adjustment.
Transportation:
For short distances dismantle the platter, remove belts and disconnect all cables. The base
with the subplatter can be transported as one, providing that it will not be tilted, as this may
cause oil leakage.
All parts are heavy, however, and can be easily damaged by sliding around a transport
vehicle. Repacking in original cutouts and boxes is , therefore, recommended.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
Phone:+ 386 4 25 35 450
Fax: + 386 4 25 35 454
E mail:
www.kuzma.si