Kuzma Stabi XL 2 101014 - Manual (Page 6)

6
Belts:
Place one belt over both motor pulleys in the lower running grooves and subplatter and
check by manual rotation that the belt runs smoothly in the middle of the grooves. Then place
the second belt in the top running grooves on the motor pulleys and subplatter. Recheck the
position of belts. See Fig. on page 2.
Power supply (PS XL2=4):
General description of PS( MCU):
The AC motor power supply generates dual sine wave ouput to control rotation and speed of
the AC sycnhronous motors. The signal is generated and controlled by a sophisticated
computer based program. This allows for very smooth generation of the sine wave with very
fine choice of speed. Each speed can be selected, finely adjusted independently and then
stored in the memory. PS is factory preset. Connect motor cables to motor outputs (any )
Sometimes it will take a few hours for a new turntable to settle for the correct speed. When
the PS is unplugged preset speeds will be stored.
Technical data:
Mass: 2 kg
Size: 120x140x400 mm
Power consumption: 50w
Number of motor connections: 2 or 4 motors
Output: 33,45 rpm( 40-100Hz, 110V)
Mains: 110V or 230V ( 50-60Hz)
Position the PS on a firm surface away from signal cables and ensure there is adequate
ventilation, ie. leave a gap of at least 2cm above the unit. Locate any of the 2 pieces of
connecting cables with DIN connectors.