Casio IT-500 - Manual (Page 35)

E-33
Performing a Full Reset (Initialization)
Performing a full reset initializes memory. This means that all data stored in the
memory (RAM) is deleted and all the settings are returned to their initial factory
defaults.
Perform a full reset whenever any one of the following conditions exists.
• When you want to delete all memory contents and return the settings to their initial
factory defaults.
• When you are no longer able to use the Handheld Terminal because you forgot your
password.
• When the Handheld Terminal does not operate normally due to a memory problem.
• When the message “A problem with memory contents has been found. ...” appears.
To perform a full reset
Important!
Performing a full reset deletes all data currently stored in the memory (RAM). If
possible, backup data of the Handheld Terminal to a computer, Flash Memory, a
memory card, or some other medium before performing a full reset.
1. Hold down the power key and push down the reset switch for about one second, until
the message shown below appears on the display.
• To cancel the full reset operation, press the CLR key.
2. Press the Trigger key. This causes the message shown below to appear.
• To cancel the full reset operation, press the CLR key.
3. Press the Trigger key again.
• Full reset is performed, all data in the memory (RAM) are erased and the start-up
screen is displayed.
Memory All Clear Warning
Proceeding with this operation deletes all data
stored in memory.
Press [Trigger key] to proceed
or [CLR key] to cancel.
Trigger
key
Memory All Clear Warning
Proceeding with this operation initializes memory.
Press [Trigger key] to proceed
or [CLR key] to cancel.
Trigger
key