Casio IT-500 - Manual (Page 41)

E-39
4. Turn on the power. This causes the Bridge Satellite Cradle/Bridge Basic Cradle
power indicator lamp to light in red.
5. Making sure that their two IR ports come into contact with each other, place the
IT-500 onto the Bridge Satellite Cradle/Bridge Basic Cradle. This causes the
Bridge Satellite Cradle/Bridge Basic Cradle power indicator lamp to light in
green.
• If the system is operating normally and data communication is enabled, the system
status indicator lamp lights in green.
• The communicator indicator lamp flashes in green when communication starts via a
serial interface (RS-232C/RS-422).
When charging is initiated, indicator 1 on the IT-500 lights up in red. When charging
has been completed, indicator 1 on the IT-500 changes color from red to green.
Important!
• A high-sensitivity communication element is used during IR data
communication.
In order to ensure successful communication, avoid using cellular phones or
other devices that emit radio wave in the area where you are performing IR data
communication.
If you need to use such a device, move away from the communicating Handheld
Terminals. In case of a cellular phone, keep it at least 30cm (
11 7 ⁄
8
" ) away.
• Take care to avoid allowing the Bridge Satellite Cradle/Bridge Basic Cradle
power contacts to become connected to each other, which creates a short.
Shorting the power contacts can damage the Cradle.