Lake Lite LL-SDL-Round v5.2 - Manual (Page 4)

Lake Lite Inc.
105 W. Simon St.
Laotto, IN 46763
Phone: 260-918-2758
Fax: 260-918-3540
E-mail [email protected]
www.lakelite.com
www.solarmarinelites.com
WARNING ! WARNING ! WARNING ! WARNING ! WARNING ! WARNING !
Changing LED Colors & LED Installation Color LED’s - Sold Separately
NOTE: Do not worry if you accidently plug the LED in backwards, it will NOT damage the circuit, the LED will simply will not
illuminate. To correct, turn the LED around and reinsert into the socket.
NOTE: Battery must have some charge in order to see if LED illuminates: Generally batteries come with a small amount of charge.
Also, LED will not illuminate if solar panel is exposed to enough light: (try in dark area)
NOTE: If using Color LEDs, there is NO way to tell which color is which until the LED is installed and illuminating.
Continue below
Make sure you have the following items seen below: Cut Longer (+) side to same length as the (-) side.
Bend LED gently as seen. NOTE bend direction.
NEW: Watch Online Video
for Installing & Changing
LED Colors!
NOTE: Battery Clip
Proper Installation of battery, battery clip & 8mm LED
POWER BOOST:
Use Jumper on power boost pins to increase
brightness of your Solar Dock Lite. NOTE:
Power Boost option uses 2X more power.
You may want to purchase higher capacity
batteries such as “AA” Size 1.2volt
Rechargeable NiMh 1500mA – 2000+mA
“U” Channel O-Ring Seal:
Please check your O-ring Seal and make sure
its properly in place, if it is twisted or out of
place, you can run a small flat screw-driver,
toothpick or other small device around the O-
Ring seal to make sure its properly in place.
When looking into the top make
sure the O-Ring “U” shaped
channel is facing upward.
Solar Dock Post Lites
MODEL: LL-SDL-Round / Square / Rectangle