Leapers 2.6 ITA Red/Green CQB Micro Dot with Integral QD Mount (SCP-DS3026W) User Manual
Page 17
15
3.
Zeroing the Dot Sight
I.
For Double Lock Turrets, finger
adjust the windage and elevation
as shown in Fig. 9. Refer to the
ZEROING section for further steps.
DO NOT over-loosen the locking screws! It may
cause the face cover to fall off if screws are backed out
too far. If, by mistake, the face lid fell off when you are
looseing the screws, please follow instructions below to
replace the face cover.
A.
Lock both screws down, making sure that they are
flush with the surface.
B.
Apply a little loctite or similar adhesive on the flat
surface of the knob. Make sure that no adhesive
gets into the screw holes or onto the screws.
C.
Carefully place the face cover back on the knob
and align with the locking holes properly. Firmly
press the face cover to achieve full contact and wait
a few seconds to let the cover adhere to the flat
surface of the knob.
WARNING FOR DOUBLE LOCK TURRETS:
Fig 9
- 3.9 ITA Red/Green CQB Dot Sight with Integral QD Mount (SCP-DS3039W) 6.4 ITA Red/Green CQB Dot Sight with 1-piece QD Rings (SCP-DS3068W) 4.2 ITA Red/Green CQB Dot with QD Mount, Riser Adaptor (SCP-DS3840W) 3.8 ITA Red/Green Circle Dot Sight w/Integral QD Mount (SCP-RG40CDQ) 3.8 ITA Red/Green Single Dot Sight w/Integral QD Mount (SCP-RG40SDQ) 3.8 ITA Red/Green CQB Dot Sight with Integral Mount (SCP-RD40RGW-A)