Compaq 1124 - Manual (Page 25)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-7
1124 100Base-TX Repeater User Guide
Writer: Chris Seiter Project: Installing the Repeater Comments: 185810/707119-001
File Name:10024_3.DOC Last Saved On:3/14/96 11:56 AM
Disconnecting Power
To power down the repeater, disconnect the power cord from the non-
switched, grounded power outlet on the wall, power strip, or grounded
extension cord. The power cord is not a TUV-tested disconnect. Therefore do
not power down the repeater by disconnecting the power cord connector from
the back of the repeater.
Replacing the Power Supply
The power supply's modular design makes the supply easy to replace. If power
supply replacement is necessary, follow the instructions under “Installing a
Redundant Power Supply Module” in the next section.
Installing a Redundant Power
Supply Module
The repeater comes with a pre-installed, 90-watt power supply module (PWR
A). You can install an optional redundant power supply module (PWR B) for
backup power. Contact your authorized Compaq reseller for information about
ordering an additional power supply module or a replacement.
Follow these steps to install a redundant power supply module.
NOTE: You can install the redundant power supply module while the main power
supply module is powered on.
1. Remove the two screws from the PWR B cover plate and remove the
plate. Be sure you keep the cover plate and screws in case you need
them for future use.
2. Carefully insert the power supply module into the opening until its 10-
pin connector engages with the internal power connector and the face
of the module is flush with the repeater's back panel.
3. Secure the power supply by tightening its two spring screws.