Lippert Components Solera® Manual Awning Crank Style - Manual (Page 3)

Rev: 07.30.2014
Page 3
Solera Manual Awning - Crank Style
Operation
Extending the Awning
1. Locate the locking latch (Fig. 1) (if equipped) on the drive side awning arm. Unlock the latch (Fig. 2).
NOTE: This latch is optional and may be installed on one or both support arms. If not installed, skip to step 2.
2. Locate the manual crank handle for the awning.
3. Insert the hook end of the crank handle into the eye bolt on the drive head (Fig. 3A).
4. Turn the crank in a counter-clockwise direction and fully extend the awning (Fig. 4).
NOTE: Full extension is considered complete when the awning valance seam reaches the leading edge of
the awning tube (Fig. 5).
Tying the roll bar down once extended will not allow the free floating support arms to work as designed
and may cause damage to the awning or RV.
Fig. 1 Fig. 3
Fig. 4
Fig. 2
Awning
Awning
Tube
Valance
Fig. 5
A