Lippert Components Solera Slider - Manual (Page 4)

Rev: 09.05.2014
Page 4
Solera® Slider Install Manual
10. Remove paper wrap from roll bar and bring fabric out one roll.
Unrolling fabric more than one roll will make the slider lose tension and create slack when closing slide.
11. Using at least two people, feed the fabric through the cord rail (Fig. 6).
Fig. 6
A
Fig. 3 Fig. 4
Fig. 5
4. Slide hex rod into roll bar arm and align the screw holes (Fig. 3A).
5. Slide end cap into other end of roll bar arm and align all three screw holes. Fasten using a pan head
screw (Fig. 3B).
6. Repeat Step 5 for other side.
7. Apply butyl tape to bracket screw holes so that the butyl tape is against the coach when mounting
bracket (Fig. 5A).
8. Place bracket against the bottom of the fascia at the top corner of the slide-out. Make sure to keep the
bracket parallel with the cord rail/fascia. Fasten using self-tapping screws (Fig. 4).
9. Repeat Step 8 for other side.
B
A
A