Lippert Components Solera Slider - Manual (Page 5)

Rev: 09.05.2014
Page 5
Solera® Slider Install Manual
12. Feed one of the hex rods into a bracket. By pulling a hex rod all the way into the bracket, the other hex
rod will fit into the other bracket (Fig. 6A).
13. Center the Solera® Slider using a tape measure.
14. Fasten the hex rods to the brackets using two self-tapping square head screws in each bracket (Fig. 7).
15. Straighten out the back of the cotter pin, grasp the roll bar to relieve tension and remove the cotter pin
(Fig. 8).
Release the roll bar slowly to avoid damage to the assembly and serious injury.
16. Test slider by operating the slide-out, being sure to watch the fabric.
17. Once the slide-out is retracted all the way, fasten fabric into the cord rail with self-tapping screws.
Fig. 7 Fig. 8