Lippert Components Touch Audio VD300WR - Manual (Page 11)

Rev: 04.10.2014
Page 11
Touch Audio VD300WR Owners Manual
Touch Audio
1. When radio is in stand-by mode, touch any button and the panel will light temporarily.
2. Press power to turn the unit on.
3. Touch mode to cycle through auxiliary, radio and disk playback.
A. To use USB or SD, unit must be on disk playback mode, then press USB/SD.
B. To switch between AM and FM, unit must be on radio mode, then press band to cycle.
I. Press preset to view the stations saved on the unit.
a. To store a station in the presets, press and hold store for 2 seconds and the station will
begin to flash.
b. Press store again to save the station to the preset, the station will stop flashing when it
has been saved.
II. To select a preset, press preset and cycle through till the preset desired is shown and press
play.
NOTe: There are 20 presets for AM and FM.
C. While on weather band mode use fast forward/rewind on the Touch Audio or up/down on the
remote to cycle through the channels in your state.
NOTe: Weather band alarm (NOAA) is active on radio, auxiliary and in standby modes only. It will last 2
minutes then turn off automatically.
D. To use DVD and CD playback unit must be on disk playback mode.
I. If there is a disk in the Touch Audio, press eject to remove it.
II. Insert a disk and it will automatically be loaded.
III. Once a disk is inserted follow the on-screen instructions to play the DVD or CD.
4. Press A, B, or C to change the speaker outputs.
NOTe: Channel A is two speakers, B is four speakers and C is six speakers.
5. Press bass boost to activate bass.
A. Use remote tone button to adjust bass and treble levels.
Radio Mode
This unit has a presetting of 10 FM and 10 AM stations. Once in radio mode:
1. Press band to choose between FM, AM, and weather band.
2. Press up/down on the remote or fast forward/rewind on the unit to select desired frequency.
3. Memory on the remote or store on the unit can memorize/store a station in the presets.
A. Press memory/store and the frequency will begin to flash.
B. Press memory/store again to save the frequency to a preset, the frequency will stop flashing when
it has been saved.
4. Press previous/next on the remote or fast forward/reverse on the unit to cycle station presets.
NOTe: If there is a weak signal adjust the antennae to the most adequate position.