Lippert Components Ground Control 2.0 - Manual (Page 5)

Rev: 04.10.2014
Page 5
Ground Control 2.0 Owners Manual FULL
Taking Up Strut Pin Slop (If J.T Strong Arm Stabilizers are installed ONLY)
1. After leveling is complete, LCD screen will read “LEVEL SUCCESSFUL/CHECK STABILIZERS.”
2. Push “FRONT” button momentarily until front stabilizer pins are tight.
3. Push “REAR” button momentarily unit rear stabilizer pins are tight.
4. Push “ON/OFF” button to turn system off.
Fig. 3
A
Reconnecting the unit to a tow vehicle
1. Be sure main power switch “ON.”
2. Loosen J.T. Strong Arm Stabilizer “T” handles. (If applicable.)
3. Push Touch Pad “ON/OFF” button to turn system on.
4. Push “DOWN ARROW” to scroll to AUTO RETRACT REAR JACKS and push “ENTER.” Rear jacks will fully
retract and stop.
5. Push “LEFT” & “RIGHT” button together. Front will raise to previous drop off height. Push ”FRONT”
button if more height is needed.
6. Back tow vehicle to align 5th wheel hitch.
7. Push “RETRACT” button. Orange LED will illuminate (Fig. 4).
8. Push the scroll arrow to display “AUTO RETRACT ALL.”
9. Push “ENTER.” Landing Gear jacks will automatically retract and then stop.
10. Raise inner drop legs on all jacks (4) and secure with quick release pull pin.
11. Turn “ON/OFF” button off.
Fig. 4 Fig. 5