Lippert Components Ground Control 2.0 - Manual (Page 6)

Rev: 04.10.2014
Page 6
Ground Control 2.0 Owners Manual FULL
Truck Hauler Operation (Manual ONLY)
1. Loosen J.T. Strong Arm Stabilizer “T” handles. (If applicable.)
2. Turn the Touch Panel “ON.” LED lights up green.
3. Push “FRONT” button to extend FRONT jacks to gain height.
4. To retract jacks:
A. Push “RETRACT” button; Orange LED lights up.
B. Push the “FRONT” button to retract jacks and hook up vehicle. Once 5th wheel is coupled, push
“FRONT” button and hold until jacks are fully retracted.
C. Let off “FRONT” button and push “ON/OFF” button to turn system off. Green light goes out.
D. Double check 5th wheel latch is secure and that all jacks are retracted.
E. Ready to tow.
Zero setting the control
1. Turn “ON/OFF” button “OFF”.
2. Push “FRONT” button 10 times.
3. Push “REAR” button 10 times.
4. Control will flash and beep, LCD says “ZERO POINT CALIBRATE”.
5. Manually operate the jacks to attain unit level condition (use carpenter’s level).
6. To memorize this level condition , press “ENTER”.
7. LCD says “ZERO POINT STABILITY SUCCESSFULLY SET”.
8. The control will then turn off.
9. Turn “ON/OFF” on to commence operation.