Lippert Components Ground Control 3.0 - Manual (Page 5)

Rev: 01.28.2015
Page 5
Ground Control 3.0 Owner's Manual
Auto Level
Auto Level Sequence
1. After unhitching from tow vehicle and parking the vehicle at a safe distance away from the unit, press
the “ON/OFF” button (Fig. 3A) and then press “AUTO LEVEL” (Fig. 3B).
Fig. 3
A
B
NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
coach until the unit has completed the leveling process. Failure to remain still during the leveling
cycle could have an effect on the performance of the leveling system.
NOTE: In order for hitch recognition feature to function, the auto level sequence MUST be started with the
front of the unit above level.
1. When Auto Level Sequence begins, the front of the unit will lower slightly to a point below level. The
coach will then stop and raise up to the point where it is level from front to rear.
2. Rear leveling jacks will be grounded.
3. A side to side leveling sequence will occur.
NOTE: At this point on the 6-point system, the two middle jacks will be grounded to stabilize the unit. These
two jacks do not level the unit.
4. Each jack will perform a final grounding touch.
5. LCD will read “AUTO LEVEL SUCCESS” (Fig. 4).
6. LCD will then read “READY Jacks: Down” (Fig. 5A), and the green LED at the center of the four jack
buttons will be illuminated (Fig. 5B).
Fig. 4 Fig. 5
B
A