Lippert Components LCI Level-Up Motorhome Leveling (2013-present) User Manual

Page 10

Advertising
background image

Rev: 08.11.2014

LCI Level-Up Motorhome Leveling (2013-Present)

Page 10

Selecting a Site

When the coach is parked on an excessive slope the leveling requirements may exceed the jack lift stroke

capability. If the coach is parked on an excessive slope, the coach should be moved to a more level surface

before the leveling system is deployed.
EXCESS ANGLE will appear on the LCD screen if the coach is 3.5 degrees out of level front to rear or side to

side. See Page 9.

Automatic Leveling Procedure

NOTE: Refer to Fig. 6, page 12, for questions regarding location and functions of the Lippert Components

Inc. Electronic Leveling System.

NOTE: Coach must be running for LCI Electronic Leveling System to operate.
1. Push ON/OFF button on Control Panel. The system is now operational and the electronic level lights

will become active.

2. Check to see that the Control Pad ENGAGE PARK BRAKE is engaged.
3. Push the AUTO LEVEL button to begin the automatic leveling cycle.
4. Push ON/OFF button to de-energize the system.

Automatic Leveling Descriptive Logic

Grounding: Steps 1-3 describe the process of how the AUTO LEVEL LOGIC extends the jacks to the ground:
1. Depending on which end of the coach is lowest to the ground, the level sensor in the brain will

activate the jacks, one at a time on the lowest end first, either front or rear.
A. Ground lowest side jack first; i.e., front passenger side.
B. Ground remaining side jack next; i.e., front driver side.

2. Together, both jacks will lift lowest end until level; i.e., front of coach will lift briefly until the coach is

level.

3. The system will then ground remaining jacks, one at a time; i.e., rear jacks.

A. Ground lowest side jack first; i.e., rear passenger side.
B. Ground remaining side jack next; i.e., rear driver side.

Leveling: Steps 4-6 describe the process of how the AUTO LEVEL LOGIC levels the coach once the jacks

have been grounded. This process may repeat several times until level.
4. Fore/Aft
5. Side/Side
6. Individual

A. Minor adjustments to limit/prevent twist

NOTE: After starting the automatic leveling cycle, it is very important that you do not move around in the

coach until the unit is level and the green LCI logo light illuminates in the center of the touchpad.

Failure to remain still during the leveling cycle could have an effect on the performance of the

leveling system.

Never lift all the wheels off the ground to level the coach! Lifting all wheels off the ground may result in

serious personal injury or death.

Advertising