Lippert Components Level Up - Manual (Page 5)

Rev: 12.15.2014
Page 5
Level Up Towable Owner's Manual
Auto Level
NOTE: Prior to unhitching from the tow vehicle, ensure unit is parked on a level surface and chock the tires
of the unit.
1. After unhitching from tow vehicle press "AUTO LEVEL" (Fig. 1F).
NOTE: Pressing any button during an Auto Level sequence will abort the auto leveling cycle.
NOTE: In order for hitch recognition feature to function, the auto level sequence MUST be started with the
front of the unit above level.
Auto Level Sequence
1. Front landing gear retract, lowering the front of the unit below level, stopping, then lifting the front
end to level the unit front to back.
2. The left side leveling jack(s) extend and raise the roadside of the unit.
3. The right side leveling jack(s) extend and raise the curbside of the unit, beginning side to side leveling.
4. The front landing gear extend to complete the leveling cycle.
NOTE: Additional left to right or front to back leveling may occur if the controller deems necessary.
NOTE: If the auto level sequence does not happen as stated above, check to ensure proper manual function
in all zones.
Hitch Recognition
1. Turn on touch pad.
2. Press the "LEFT" and "RIGHT" buttons simultaneously (Fig. 1H and 1I).
3. The front of the unit will raise to the height where the auto level sequence was started.
NOTE: If the auto level sequence was started with the front of the unit in a below level condition, the Hitch
Recognition will not function and the LCD will display “Feature Disabled." In order for the hitch
recognition feature to function, the auto level sequence MUST be started with the front of the unit
above level.
4. Connect tow vehicle and make sure 5th wheel and hitch are connected and locked.
5. Push “UP” arrow (Fig. 1A) until ”AUTO RETRACT” appears in LCD screen.
6. Push “ENTER” (Fig. 1C). System will immediately retract all jacks.