Lippert Components Hydraulic Slideout And Hydraulic Landing Gear (hlg) System User Manual
Page 9
EXTENDING SLIDEOUT ROOM
1.
Level the unit.
2.
Verify the battery is fully charged and hooked-up to the electrical system.
3.
Remove the transit bars (if so equipped).
4.
Press and hold the IN/OUT switch (Fig. 1b) in the OUT position until the
room is fully extended and stops moving.
5.
Release the switch, which will lock the room into position.
RETRACTING SLIDEOUT ROOM
1.
Verify the battery is fully charged and hooked-up to the electrical system.
2.
Press and hold the IN/OUT switch (Fig. 1a) in the IN position until the room
is fully retracted and stops moving.
3.
Release the switch, which will lock the room into position. NOTE: If the
slideout switch is held after the room in fully retracted, the control will sense
that the room has stopped and will shut off the motor after a few seconds.
4.
Install the transit bars (if so equipped).
9