Lippert Components 3 X 3 Slideout System - Manual (Page 7)

OPERATING SYSTEM
WARNING
FAILURE TO ACT IN ACCORDANCE WITH THE FOLLOWING MAY
RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
ALWAYS MAKE SURE THAT THE SLIDEOUT ROOM PATH IS CLEAR
OF PEOPLE AND OBJECTS BEFORE AND DURING OPERATION OF
THE SLIDEOUT ROOM.
ALWAYS KEEP AWAY FROM THE SLIDE RAILS WHEN THE ROOM IS
BEING OPERATED. THE GEAR ASSEMBLY MAY PINCH OR CATCH
ON LOOSE CLOTHING CAUSING PERSONAL INJURY.
INSTALL TRANSIT BARS (IF SO EQUIPPED) ON THE SLIDEOUT
ROOM DURING STORAGE AND TRANSPORTATION.
EXTENDING SLIDEOUT ROOM
1. Level the unit.
2. Verify the battery is fully charged and hooked-up to the electrical
system.
3. Remove the transit bars (if so equipped).
4. Press and hold the IN/OUT switch (Fig. 5B) in the OUT position until
the room is fully extended and stops moving.
5. Release the switch, which will lock the room into position.
Note: If the slideout switch is held after the room in fully extended, the
control will sense that the room has stopped and will shut off the motor
after a few seconds.
RETRACTING SLIDEOUT ROOM
1. Verify the battery is fully charged and hooked-up to the electrical
system.
2. Press and hold the IN/OUT switch (Fig. 5C) in the IN position until
the room is fully retracted and stops moving.
3. Release the switch, which will lock the room into position. NOTE: If
the slideout switch is held after the room in fully retracted, the control
will sense that the room has stopped and will shut off the motor after
a few seconds.
4. Install the transit bars (if so equipped).
7