Longshine LCS-6022 - Manual (Page 2)

Overview
This PCI I/O card is a dual UART with 1284 printer interface port controller with PCI bus interface and uses an all-in-one solution
from NeMos Technology, which provides superior performance and unmatched data transfer rates. The most advanced feature is it
uses of a single interrupt, which is set automatically by the host system and share among all on-board I/O ports and supports printer
interface as well as PS2, EPP & ECP modes.
Features
Chipset: NetMos Nm9835
OS power: Single 5V operation
Bus: PCI 2.1s 32bit, 33MHz
Data Transfer Rate: 1Mbytes/s (serial port)
Data Transfer Rate: 1.5Mbytes/s (parallel port)
Selectable receive trigger levels
PCI compatible Dual UART
Multi-mode compatible controller (SPP, PS2, EPP& ECP)
Modem control signals
On chip oscillator
16Byte transmit-receive FIFO (UART)
Software programmable mode selects
Programmable baud rate generator
Support plug & play features and makes installation fast and easy.
Supports Windows98, Windows95, Windows2000 & Windows NT 4.0.
Installing the PCI I/O controller card into your computer
1. Turn off your computer and all external devices connect it.
2. Remove the computer’s cover. Refer to your computer user’s manual for more details.
3. Find an available PCI slot and remove the metal bracket. Save the bracket screw for later use.
4. Align the PCI I/O controller horizontally with respect to the PCI slot and insert it into the slot firmly and evenly. Take care not to
force it into the slot. Once you have properly positioned the PCI I/O controller card into the slot, fasten it to the computer case
with the bracket screw you have saved.
5. Replace the computer’s cover.
6. Turn your computer on. You are now read to install the driver!
Driver Installation
Windows 95/98/2000
Once the PCI I/O card is installed and the computer is restarted, Windows will detect the board and attempt to install driver for it.
1. Start Windows 95/98/2000
Jul/05 2 MN0NM9835000