Longshine LCS-883C-TB - Manual (Page 12)

10Base-T to 10Base-2 Converter
Connections
10Base-T Connection
1. Make sure that the length for straight through twisted pair
cable between 10Base-T device (hub or switch) and
converter is no greater than 100 meters.
2. Connect one end of twisted pair cable to RJ-45 jack on the
converter and the other to the RJ-45 jack on the 10Base-T
device.
10Base-2 Connection
To connect to an Ethernet using 10Base2 cable, do the following:
1. Attach the supplied BNC T-connector to the converter’s
BNC connector.
2. Connect one end of a Thinnet (10Base2) coaxial cable to the
BNC T-connector attached to the media converter.
3. Connect the other end of the coaxial cable to the BNC T-
connector attached to the Ethernet device.
Note: If either your converter or the Ethernet device is an end
node, attach a BNC terminator to the open connector on the
BNC T-connector.