Coverter mounting, Appendix b – Longshine LCS-883C-TB User Manual
Page 15
10Base-T to FL Converter
Appendix B
Coverter Mounting
This converter can be placed in any location that will make its
installation convenient. If you place the converter on a horizontal
surface or on top of existing networking equipment, please affix the
four rubber pads included in the package.
This converter can also be mounted on a vertical surface. Simply
use the underside of the unit as a template to measure and mark
out the position of the holes on to the surface where the unit is to
be installed. Then use two screws to mount the converter firmly in
place.
Please exercise caution when using power tools. Also, install this
unit away from damp or wet locations, or in close proximity to very
hot surfaces. These types of environments can have a detrimental
effect on the converter and cables. An ideal location is a lightly
cooled place such as a typical equipment room.