Longshine LCS-C842SC - Manual (Page 15)

Enhanced 10/100Base-TX to 100Base-FX Converter
- 25 -
seals off the front of Chassis and allows it to function
correctly.
Step 1 Using a Phillips screwdriver, remove two screws from
the side panels on the converter.
Step 2 Place the converter and brackets on a flat horizontal
surface as illustrated above. Secure the brackets by
replacing the screws.
Ensure that the rails are flush-mounted with the underside of
the Converter. The Converter is now ready for loading into the
Chassis.
Enhanced 10/100Base-TX to 100Base-FX Converter
- 26 -
Installing the Converter
Once the Converter has been attached to the bracket,
it can be installed into the Chassis. Special care must
be taken to ensure the correct mating of the power
connector. Align the Converter so that it fits between
the upper and lower guide rails.
Warning Always ensure that the converter
power socket is positioned at the base of the
Chassis. Never force the Converter into the
Chassis - check power socket position and
alignment.