Longshine LCS-FS6116-C - Manual (Page 2)

Introduction
This device is a powerful, high-performance Fast Ethernet switch,
with all 16 ports capable of 10 or 100Mbps auto-negotiation
operation (NWay), which means the switch could automatically
negotiate with the connected partners on the network speed and
duplex mode without bandwidth congestion issue. It is ideal for
micro-segmenting large networks into smaller, connected subnets
for improved performance, enabling the bandwidth demanding
multimedia and imaging applications. This switch also supports auto
MDI / MDI-X function. Each port could be used to connect to
another switch or hub without crossover RJ-45 cable.
Store-and-forward switching mode promises the low latency plus
eliminates all the network errors, including runt and CRC error
packets. To work under full-duplex mode, transmission and
reception of the frames can occur simultaneously without causing
collisions as well as double the network bandwidth. And polarity
correction function can correct polarity errors in the 10 BASE-T
mode.
The switch is plug and play without any software to configure and it
also fully complies with all kinds of network protocols. Moreover, it
supports IEEE 802.3az Energy Efficient Ethernet (EEE) ability to
promise operation in Low Power Idle Mode to save power
consumption.
Before you start to install the switch, check the following contents in
this package:
1. One 16-port Fast Ethernet switch
2. One power cord
3. Four rubber feet
4. Wall-mount plastic and screws
2
5. User’s manual