LR Baggs Five.O. Ukulele Pickup - Manual (Page 3)

saddle slot and no less than 3/32”. To avoid kinking and damaging the pickup, slightly round the top edge of
the hole with an exacto blade or small fi le.
installing the pickup
To make installing the pickup easier, we have included a green monofi lament line for pulling the pickup
through the hole. There is a loop tied on one end to keep the line from falling into the instrument. Slip the side
without the loop down through the hole in the saddle slot and feed it up through the soundhole. Thread the
line through the hole in the guide at the end of the pickup and tie a knot to secure it (see fi gure 2).
fi g. 2
After the wire and line are connected, pull up on the line above the bridge and guide the pickup into the
saddle slot. Using sharp cutters, remove the guide from the pickup just beyond the tapered section leaving a
small portion of the soldered braid intact (approximately 1/16” long) (see fi gure 3 on next page). Finally, lay
the pickup down in the saddle slot.