LR Baggs Venue DI - Manual (Page 7)

L. Volume
The master volume, located in the upper right of the control panel, will be used to set the
level of the sound coming out of the 1/4” output ONLY. It will not effect the transformer
coupled D.I. Output, which is pre-set at line level. This will allow you to adjust the level to
your amplifier without changing the level to the PA system. However, both the D.I. and
1/4” output will mute when the mute/tune is engaged.
F O O T S W I T C H E S
M. Mute/Tune
Use the switch to engage or disengage the mute/tune feature. See the “Tuner” section
above for more details on the tuner.
N. Boost (0-9dB)
The Boost feature allows you to boost your volume level for a solo or to compensate for
changes in playing style. We’ve provided a boost level-adjustment on the back panel to
give you the ability to pre-set your desired amount of boost.
NOTE: The boost feature on this unit comes after the clip meter in the signal path, so it will
not show up on the clip meter when it is engaged. Therefore, it is VERY IMPORTANT to set the
sound system to allow for the maximum boost that you have chosen.
B O T T O M
Battery Drawer
Lift the tab on the door to gain access to the battery compartment. Any standard 9V
battery should work. Be sure to maintain the correct polarity by matching the plus (+)
sign on the base of the compartment to the plus (+) sign on the battery, which is the
smaller of the two contact points.