MF Digital CD-QuadraPRO (Rev: 08/01/02) - Manual (Page 38)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 QuadraPRO LX Operator’s Guide
Document Revision: 080102
Page 37
3) Lay the printer on its back and place the remaining bracket on the printer as pictured
below. Line up the holes and fasten in place using four countersunk screws provided.
Mounting the Printer
• Remove the two thumb-screws from
the bracket attached to the top of the
drive bays.
• Loosen the three screws in the
bracket attached to the printer.
• Gently place the printer on the top of
the drive bays.
• Line up the holes from which you
removed the screws in the lower drive
bay bracket with the key-ways of the
bracket attached to the printer, and
replace screws loosely threaded.