MIDI Solutions Footswitch Controller User Manual
Page 11
11
TAP TEMPO
To program the Footswitch Controller to operate in Tap Tempo mode sending MIDI timing clocks at a tempo
corresponding to the taps of the footswitch, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
To program the Footswitch Controller to operate in Tap Tempo mode and also send a Note or Control Change
message along with each tap of the footswitch, send it the following System Exclusive programming command:
(
is optional)
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= 01 to send Note, 02 to send Control Change
= Note number if
= 01, Control Change number if
= 02
= Note velocity if
= 01, Control Change value if
= 02
= MIDI channel of outgoing Note or Control Change message (see MIDI channel table at end)
is optional. If inserted, nothing is sent on release of the footswitch. If not inserted then a Note-Off (if
= 01)
or Control Change of value zero (if
= 02) is sent on release of the footswitch.
To program the Footswitch Controller to operate in Tap Tempo mode and also respond to a Note or Control Change
message (of value>0) as a tap, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= 11 for Note, 12 for Control Change
= Note number if
= 11, Control Change number if
= 12
= MIDI channel of incoming Note or Control Change message (see MIDI channel table at end)
To program the Footswitch Controller to operate in Tap Tempo mode and also to respond to a Note to specify the
exact tempo in bpm, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= offset added to Note number to obtain tempo
= MIDI channel of incoming Note message (see MIDI channel table at end)
To program the Footswitch Controller to operate in Tap Tempo mode and also to respond to a Control Change
message to specify the exact tempo in bpm, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Control Change number
= offset added to Control Change value to obtain tempo
= MIDI channel of incoming Control Change message (see MIDI channel table at end)
F0 00 00 50 04 0B F7
F0 00 00 50 04 0B aa nn vv cc (00) F7
00
aa
nn
aa
aa
vv
aa
aa
cc
00
aa
aa
F0 00 00 50 04 0B aa nn cc F7
aa
nn
aa
aa
cc
F0 00 00 50 04 0B 21 bb cc F7
bb
cc
F0 00 00 50 04 0B 22 nn bb cc F7
nn
bb
cc