Important safety instructions – COBY TF-DVD7006 User Manual

Page 5

Advertising
background image

Page 

Coby Electronics Corporation

www.cobyusa.com

Page 

www.cobyusa.com

Page 

Grounding or Polarization: This product may be equipped with a polarized alternating-

current line plug that has one blade wider than the other. This plug will only fit into the power

outlet in one direction. This is a safety feature. If you are unable to insert the plug fully into the

outlet, try reversing the direction of the plug. If the plug should still fail to fit, your outlet may

be obsolete; contact a licensed electrician to replace it. Never attempt to defeat the safety

purpose of the polarized plug.

Power-Cord Protection: Care must be taken to ensure that power supply cords are routed

so as to avoid being damaged, such as by being walked on or pinched by items placed upon

or against them. You should pay particular attention to cords at plugs, convenience recep-

tacles, and at the point where they exit from the product.

Protective Attachment Plug: The product may be equipped with an attachment plug with

overload protection. This is a safety feature. See the operating instructions for replacement

or directions to reset the protective device. If replacement of the plug is required, please

consult an authorized service technician, and make sure s/he has used a replacement plug

that has the same overload protection as the original plug as specified by the manufacturer.

Outdoor Antenna Grounding: If an outside antenna is connected to the product, be sure

the antenna system is grounded so as to provide some protection against voltage surges and

built-up static charges. Article 810 of the National Electrical Code, ANS/NFPA 70 provides

information with regard to proper grounding of the mast and supporting structure, ground-

ing of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location

of antenna-discharge unit, connection to grounding electrodes, and requirements for the

grounding electrode (see figure).

Lightning: Lightning can cause power surges, which may damage or destroy your product.

For added protection, unplug it from the wall outlet and disconnect the antenna or cable sys-

tem during a lightning storm or when it is left unattended and unused for long periods of time.

Power Lines: An outside antenna system should not be located in the vicinity of overhead

power lines or other electric light or power circuits, or where it can fall into such power lines

or circuits. When installing an outside antenna system, extreme care should be taken to keep

from touching such power lines or circuits, as contact with them might be fatal.

14.

15.

16.

17.

18.

IMPORTANT SAFETY INSTRUCTIONS

Advertising