MOOER Ana Echo User Manual

Precautions, Main features

background image


Power Supply

Always turn off the power of this and all other equipment before connecting or
disconnecting, this will help prevent malfunction and / or damage to other devices.
Also make sure to disconnect all connection cables and the power cord before
moving this unit.
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth.
Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents,
cleaning fluids, or chemical-impregnated wiping cloths.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.

To avoid deformation, discoloration, or other serious damage, do not expose
this unit to the following conditions:

Direct sunlight

Heat sources

Magnetic fields

Extreme temperature or humidity

Excessive dusty or dirty location

High humidity or moisture

Strong vibrations or shocks

Please connect the designated AC adapter to an AC outlet of the correct voltage.
Please be sure to use only an AC adapter which supplies 9V (±10%) DC, center
minus. The maximum working voltage shall not exceed 12V, otherwise may be
dangerous equipment damage, fire or other problems.
Unplug the AC power adapter when not using or during electrical storms.


FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
This device may not cause harmful interference.

This device must accept any interference received, including interference
that may cause undesired operation.

Power Requirements: AC adapter 9V DC (center minus plug),
recommended to use Mooer Micro Power

1. TRUE BYPASS Footswitch:

Push down the footswitch to toggle
between on and bypass status.


Shows the on/off status of Ana Echo,
when the LED is lit the effect is

3. DC IN Power Jack:

For power supply, use a 9-volt

DC regulated AC adapter (plug
polarity is positive on the barrel

and negative in the center).

4. INPUT Jack:

1/4” mono audio jack, for

connecting guitar.

5. OUTPUT Jack:

1/4” mono audio jack, outputs

the signal.

6. ECHO Knob:

Adjusts the level of delay effects.

 DC 9V adapter power supply

 Very small and compact design
 True bypass switch

 Full metal shell

Full analog circuit, warm, clear, smooth analog delay sound

Main Features

7. INTENSE Knob: Adjusts the feedback of delay effects.
8. RATE Knob: Adjusts the delay time.

Input: 1/4” monaural jack (impedance: 470k Ohms)
Output: 1/4” monaural jack (impedance: 470 Ohms)

Current Draw: 26 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 160g
Accessories: Owner’s Manual


Disclaimer: Any specification’s update won't be amended in this manual.

Analog Delay Pedal







Delay Time: 20ms-300ms

Table of contents