MOOER VEM Box - Manual (Page 9)

the setting up the master volume, master volume of VEM Box (when
08
Operation
Patch Selecting
Power On
Plug the cable of AC Adapter
(9V, 300mA, center minus) into
the [DC 9V] Jack, when using
batteries, plug the Mic cable
into [MIC IN] this jack will turn
the device on.
Selecting Patches
Set the Module Selector to [PATCH],
the LED display will show the
information
of bank and patch number, step on
[PATCH +/-] footswitch to change patches
(Hold one footswitch to switch patches
quickly).
Pressing [PATCH +] footswitch time and again (or holding [PATCH +]
footswitch) cycles through patches in the order ~ ... ~ , ~ ...
~ , Pressing or holding [PATCH -] footswitch will switch
patches in
the opposite order.
Adjusting the master volume
Set the Module Selector to [PATCH], rotate [VALUE] knob to adjust
LED display will show the current level). The range of
master volume is ~ , 70 is the default value.
01
03
02
BANK PATCH
EDIT
footswitches together to enter bypass mode. LED will display ,
Entering Bypass Mode
When in PATCH mode, press both [PATCH –] and [PATCH +]
and all of the effects will be turned off.
04
BANK PATCH
EDIT
[PHONES]
INST.THRU DC9V INST.IN OUTPUT
MIC IN
DATA
DATA
BANK Bank
name Patch PATCH
name
EDIT DATA