Cisco Cisco Unified Wireless IP Phone 7925G - Manual (Page 74)

66 OL-16132-01
Tip
If you unplug the headset or remove the phone from the desktop charger, the phone reverts to the
speaker mode for features that typically use the speakerphone for incoming calls, such as AutoAnswer
or intercom calls.
Obtaining Headsets
Your phone supports wired headset jack types with a 2.5 mm, 3-band/ 4 connector. For information
about purchasing headsets, see
Headset Information, page 16 .
Using Bluetooth Wireless Headsets
Your phone supports the use of Bluetooth wireless headsets. Enable the Bluetooth setting on your
phone before performing tasks such as scanning, pairing, and unpairing.
Note Before pairing the Bluetooth headset with the phone, follow the instructions in the headset
documentation to enable it for operation.
Switch to the speaker (from
the handset) during a call Press and hold until the icon appears.
Press and hold to toggle back to the handset.
Adjust the volume level for a
call During a call, press to adjust the volume for the handset, speaker,
or headset.
Note The new volume level is preserved for future calls after the
phone is powered off.
If you want to... Then...