Safety instructions – MUTEC MC-1.2 User Manual

Page 4

Advertising
background image

4

Safety Instructions

General Instructions

To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture,
direct sunlight or excessive heat from sources such as radiators or spotlights. No user service-
able parts are inside. Repair and maintenance must be carried out by qualified personnel au-
thorized by MUTEC GmbH! The unit has been designed for operation in a standard domestic
environment. Do NOT expose the unit and its accessories to rain, moisture, direct sunlight or
excessive heat produced by such heat sources as radiators or spotlights! The free flow of air
inside and around the unit must always be ensured.

Initial Operation

Prior to the initial operation of the unit, the appliance, its accessories and packaging must
be inspected for any signs of physical damage that may have occurred during transit. If the
unit has been damaged mechanically or if liquids have been spilled inside the enclosure, the
appliance may not be connected to the mains or must be disconnected from the mains im-
mediately! If the unit is damaged, please do NOT return it to MUTEC GmbH, but notify your
dealer and the shipping company immediately, otherwise claims for damage or replacement
may not be granted.
If the device is left in a low-temperature environment for a long time and then is moved to
a room-temperature environment, condensation may occur on the inside and the exterior.
To avoid short-circuits and flashovers, be sure to wait one or two hours before putting the
device into operation.

Power Supply

The device contains a self-adapting wide-range power supply supporting the majority
of global standard line voltages within a range of 90…250 V, with no need for making
adjustments. Make sure that your line-voltage source provides a supply voltage within the
specified range. In addition, make sure that the device is properly grounded via the local
electric installation.
Please use the enclosed power cord (see packaging) to connect the unit to the mains. Switch
the unit off before you attempt to connect it to the mains. Connect the power cord to the
unit, then to a standard 3-pin mains outlet. To draw the power cord, never pull on the cable
but on the mains plug!
The unit must be grounded during operation!
For information on the power-inlet wiring, refer to the »Wiring of connectors« section in the
appendix. Disconnect the device from the mains when not using it for an extended period!

This symbol, a flash of lightning inside a triangle,
alerts you to the presence of uninsulated dangerous
voltage inside the enclosure - voltage that may be

sufficient to constitute a risk of shock.

This symbol, an exclamation mark inside a triangle,
alerts you to important operating or safety instruc-
tions in this manual.

Declaration of Conformity
We herewith confirm that the product complies with the
European Commission’s standards on electromagnetic
compatibility.

Interference emission:

EN 50081-1, 1992

Resistance to interference:

EN 50082-1, 1992

Presupposed as operation condition is that all clock outputs are
connected with high-quality and good shielded BNC 75 ohms
cable.

!

R I S K O F

ELECTRICAL SHOCK!

C A U T I O N

!

Advertising